Aruba 2530 24G Switch
J9776A Specifications |
|
|
Type |
Aruba 2530-24G Switch |
|
System specifications |
|
|
Ports |
|
|
Memory and processor |
Processor: ARM9E @ 800 MHz, 128 MB flash, 256 MB DDR3 DIMM; packet buffer size: 1.5 MB dynamically allocated. |
|
Mounting |
Mounts in an EIA-standard 19-inch telco rack or equipment cabinet (rack-mounting kit available); horizontal surface mounting; wall mounting. |
|
Management |
IMC – Intelligent Management Center; command-line interface; Web browser; configuration menu; Out-of-band management (serial RS-232C or Micro USB); IEEE 802.3 Ethernet MIB; Repeater MIB; Ethernet Interface MIB. |
|
Performance (IPv6 Ready Certified) |
|
|
1000 Mb latency |
< 2.3 µs (LIFO 64-byte packets) |
|
100 Mb Latency |
< 7.4 µs (LIFO 64-byte packets) |
|
Throughput |
Up to 41.6 million pps (64-byte packets) |
|
Switching capacity |
56 Gb/s |
|
MAC address table size |
16000 entries |
|
Physical specifications |
|
|
Dimensions (W x D x H) |
44.3 x 25.4 x 4.45 cm (17.44 x 10.00 x 1.75 in) (1U height) |
|
Weight |
2.77 kg (6.1 lb) |
|
Electrical specifications |
|
|
Maximum heat dissipation |
164 BTU/hr (173.02 kJ/hr) |
|
Voltage |
100 – 127 / 200 – 240 V ac |
|
Current |
.6/.4 A |
|
Idle power1 |
28.8 W |
|
Maximum power rating2 |
48.0 W |
|
Frequency |
50/60 Hz |
|
NOTE: 1: Idle power is the actual power consumption of the device with no ports connected. 2: Maximum power rating and maximum heat dissipation are the worst-case theoretical maximum numbers provided for planning the infrastructure with fully loaded PoE (if equipped), 100% traffic, all ports plugged in, and all modules populated. |
|
|
Environmental specifications |
|
|
Operating temperature |
0° to 45°C (32° to 113°F) |
|
Operating relative humidity |
15% to 95% @ 40°C (104°F), noncondensing |
|
Non-operating/storage temperature |
-40° to 70°C (-40° to 158°F) |
|
Non-operating/storage relative humidity |
15% to 90% @ 65°C (149°F), noncondensing |
|
Altitude |
Up to 3 km (10,000 ft) |
|
Acoustic |
Power: 26.4 dB, Pressure: 34.0 dB |
|
Safety agency certifications |
|
|
Safety |
UL 60950-1; CAN/CSA 22.2 No. 60950-1; EN 60825; IEC 60950-1; EN 60950-1 |
|
NOTE: IEEE 802.3az applies to Gigabit models only; IEEE 802.3at and IEEE 802.3af apply to PoE+ models only. When using SFPs with this product, SFPs with revision “B” or later (product number ends with the letter “B” or later, e.g., J4858B, J4859C) are required. |
|
